
To further refine the job schedule, click the Settings tab. Three sub-options
are available.
● Scheduled Task Completed
▶ Delete the task if it is not scheduled to run again.
This task is useful for tasks scheduled to run only once.
▶ Stop the task if it runs for:
Specify how long after the task has begun it should be stopped.
● Idle Time
▶ Only start the task if the computer has been idle for at least:
Specify how long (in minutes) must pass without mouse or keyboard use
before the scheduled task starts.
▶ If the computer has not been idle that long, retry for up to:
Specify how long (in minutes) the task should keep checking to see if the
computer is idle.
▶ Stop the task if the computer ceases to be idle.
Specify whether the task should be stopped if you start to use the computer
while the task is running.
● Power Management
▶ Don't start the task if the computer is running on batteries.
Specify whether the task should be prevented from starting while your
computer is running on batteries. By selecting this check box you can
extend the life of your batteries.
▶ Stop the task if battery mode begins.
Specify whether the task should be stopped when your computer starts
running on batteries.
▶ Wake the computer to run this task.
Specify whether the computer should run the scheduled task even when
in the Sleep mode.
External Program
The job can run other command before or after backup, and the command can
be .exe, .com or .bat, or a specific type of event such as "shut down computer
after backup finished".
To execute the command when backup begins, follow these steps:
1. Click External Program
2. Select Before Job Execution option.
3. Click Browse to select command files to execute.
4. Click OK.
To execute command after backup finished, follow these steps:
1. Click External Program
2. Select the After Job Execution option.
Backup
150
BitDefender Total Security 2011
Comentarios a estos manuales